How to install worm reducer. This paper mainly describes the installation relationship between shaft mounted reduction motor and working machine, the connection between worm reduction motor and working machine, and the installation of counter torque support.
The output shaft structure of the worm reducer can not bear the axial hammering force. K series spiral bevel gear reducer can be screwed into the screw hole at the shaft end and pressed into the connector during installation. The eyebolt on the reducer is only for lifting the reducer. The irrigation in the cement slurry of the reducer shall be dense, and the installation shall be free of bubbles, voids and other defects.
For the connection between the worm reduction motor and the working machine, the counter torque support shall be installed on the side of the working machine facing the reducer to reduce the bending moment attached to the shaft of the working machine. The shaft sleeve at the connecting end of the counter torque support and the fixed support uses elastomers such as rubber to prevent deflection and absorb the torque fluctuation.
Through the above description of the worm reducer reduction motor, you should have an understanding of the reduction installation
Only effective installation can be used correctly, and the installation method is very particular.